![]() Mitsubishi Outlander (no ecuflash support, do not try, outlander may not start after you try, use MMCFLASH only) Mitsubishi Lancer RalliArt (2012) OpenPort 2.0 recommended. ![]() ![]() Mitsubishi Lancer Evo 9 (2005, 2006) OpenPort 1.3U recommended. Mitsubishi Lancer Evo 8 MR (2005) OpenPort 1.3U recommended. Mitsubishi Lancer Evo 8 (2003, 2004, 2005) OpenPort 1.3U recommended. Mitsubishi Lancer Evo 7 (2001, 2002) OpenPort 1.3U recommended. Supported ROM metadata XML definition files: (do not try to reflash your car with ecuflash unless your vehicle is listed here) Tap “NO” for not to proceed the same VIN.(includes drivers for OpenPort 1.3U and Openport 2.0 cables) Windows XP / Vista / 7 / 8 / 8.1 and Windows10īuy ECUflash 1.3U and 2.0 USB Programming Cables here When finished, return the interface to the Data Link Connector.) ![]() If there are no Controller Specific Instructions, turn the ignition off for 30 second to reset the controller.Ĭlearing DTCs will erase stored history data from alll controllers on the Data Link.Ĭontroller currently in use, Move your interface to any additional auxiliary Data connectors on the vehicle to clear DTCs from other controllers. Programming complete, and read the post programming instructions and tap OK to go on. Page down to read ECM information and tap OK to download files. Make sure MaxiSys is connected to the internet before connection” Please use the USB cable to connect MaxiFlashPro to MaxiSys. The technician may want to record DTCs and Freeze Frame Data befor continuing. Switch MaxiFlashPro device on and wait for the device to get ready.Īfter Programming, technician will be given the opportunity to clear diagnostic trouble codes from all ECUs on the vehicle. Verify the vehicle battery fully charged.Ĭonnect MaxiFlashPro to Data Link Connector. ![]() “Connect MaxiFlashPro to the vehicle and MaxiSys. Tap “Yes” for the correct auto scan report.ĭo the following instruction according to the Tap the second button on the top and select “Auto detect”. Here is the step-by-step instruction about ECU reprogramming with Autel MaxiFlashPro J2534 and Autel MS908pfor sharing. A little expensive, and it will be better if it can be sold as a combination □ But, worth every penny. Last week, I got Autel MaxiFlash Elite Pro J2534 and MaxiSys Pro MS908Pshipped from China. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |